Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 28/48
5. Set the Format to ASCII-AlphaNumeric.
6. Check the other settings, see the example below. Click
OK.
The identifier type settings must match the settings in AEOS, see section 4.4.
7. Right-click the IPBadge AEbc, and click Properties.
8. Select
Badge type Generic 0.0.
9. Open the Badge device type editor, select
Tattile/ANPR car plate and Listening TCP port
32000. The Listening TCP port number must match the server port number set in the
ANPR Access reader (see section 4.2)
To Next Page
Loading...