Nedap AP7803 - Configuring AEmon for TCP;IP (with IpBadge)

Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 33/48
5.2 Configuring AEmon for TCP/IP ─ with IpBadge
The IpBadge AEbc supports the ANPR LUMO from AEOS version 3.4.0.14 and AEOS version
2019.1.2 onwards. With older AEOS versions, use the Generic Message Mapper AEbc instead. For
instructions, see section 5.3.
To configure the AEOS Blue controller for the ANPR LUMO reader in Aemon with the IpBadge AEbc,
take the following steps:
Configure the identifier type in AEmon
6. Start AEmon
7. In AEmon, create/open the configuration, including the AP7803 AEOS Blue controller, the
IPBadge AEbc and the StandardDoor access point (see the AEOS Access Points and
Entrances manual).
8. Right-click the
StandardDoor AEbc, and click Properties.
9. Open the Identifier type editor and select Generic.
Step
01