Nedap AP7803 - Page 32

Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 32/48
4. Enter the correct settings, as shown in the tables below. The Server IP address that you
must enter here is the IP address of the AEOS Blue controller (see the AEOS hardware
configuration manual). The
Server port number must match the server port number set in
AEmon (see sections 5.2 and 5.3).
With the IpBadge AEbc:
1
Property
Value
IP
IP address of the AEOS Blue controller
PORT
12500
SEND ASYNCH
✔
MESSAGE
<%LP%>
With the Generic Message mapper AEbc:
1
Property
Value
IP
IP address of the AEOS Blue controller
PORT
10000
SEND ASYNCH
✔
MESSAGE
%LP%%CR%
5. Click SAVE.
1
The IpBadge AEbc supports the ANPR LUMO from AEOS version AEOS version 2019.1.3 onwards. When the
IpBadge AEbc does not support the ANPR LUMO, use the Generic Message Mapper AEbc instead.