4 Installation PowerRouter • Solar Inverter • Installation manual
28
EN
4.12.4Register the PowerRouter on www.myPowerRouter.com
1. Make sure you have the Part.no., Serial no., and Control code available as mentioned on the type
label of the PowerRouter (figure 1).
2. Check the internet connection via menu > service > status > internet connection. The display should
show OK.
3. Go to a computer and open www.myPowerRouter.com.
4. In the login screen click New user (figure 18).
5. Fill out the Part.no., Serial no., Control code and click Register (figure 19).
6. Fill out the fields in the window (figure 20), and click Continue.
7. Fill out the fields in the window (figure 21), and click Continue.
8. You will receive a confirmation e-mail.
4.12.5Register additional PowerRouters on one login
You can register two additional PowerRouters on the same login. To do this:
1. Login on www.myPowerRouter.com.
2. Click My PowerRouter.
3. Click New PowerRouter (figure 22).
4. Fill out the Part.no., Serial no., Control code and click Register PowerRouter (figure 23).
• The PowerRouter internet connection will not work if a proxy server is being used.
• Do not use the AC local out of the PowerRouter to provide power to the internet router, or internet
switch, the connection will be lost during a reset.
• The PowerRouter only uses internet port 80. This is the default setting on most networks.
• The PowerRouter needs a DHCP server within the network. This should be provided by the internet
router or the intenet switch.
• To test the connection, connect a PC to the connection that you will use for the PowerRouter. Open a
web page. If the web page opens, the connection works.
• The maximum length of the CAT5e UTP cable is 20 meters. If you need to clear a longer distance,
you can use an additional router, and an additional cable of 20 meters.
• Powerline communication may result in an unreliable internet connection.
To Next Page
Loading...
Need help?
General
