Nedap SmartFlow User Manual

Nedap SmartFlow / Installation manual
Version 01.001 / 2021 / EN
15
Dairy Farming
a. Use the drilling template that is delivered with the SmartFlow to mark 3 drilling holes on the wall or
panel.
b. Drill the holes.
c. Mount the bracket using 3 hex bold screws or hex head lag wood screws (M6, at least 20 mm length)
with washers.
Tighten the 2 lower screws hand-tight. These screws are used to level the SmartFlow.

Nedap SmartFlow Specifications

General

Brand	Nedap
Model	SmartFlow
Category	Farm Equipment
Language	English