Nedap SmartFlow User Manual

Nedap SmartFlow / Installation manual
Version 01.001 / 2021 / EN
41
Dairy Farming
8 Maintenance
Caution
• Always turn off the mains power supply when working on the electrical installation.
• Always turn off the air pressure supply when working on the pneumatic installation (if applicable).
• Never power wash the electrical components of the installation.
• Do not use corrosive and/or toxic cleaning agents.
• Any damage and/or accelerated wear due to non-compliance or complete lack of maintenance is not
covered by the manufacturer's warranty.
• Any damage caused by power washing or any other form of high pressure washing is not covered by the
manufacturer's warranty.
8.1 Maintenance scheme
When Part Action Who
After each milk
session
SmartFlow Clean the SmartFlow following the instructions described
in Cleaning (page 38)
User
Every 2 years
or after 12000
milkings
• Main valve
module
• Seal
Replace with parts delivered in the Nedap SmartFlow
Valve Module replacement set:
• Replace the valve module
• Replace the seal
Installer
Float is broken Float Replace the SmartFlow Float: Replace the SmartFlow
Float (page 41)

8.2 Replace the SmartFlow Float
When the SmartFlow Float needs to be replaced, proceed as follows:

Nedap SmartFlow Specifications

General

Brand	Nedap
Model	SmartFlow
Category	Farm Equipment
Language	English