EasyManua.ls Logo

Nemaxx 330 - INFLATING THE BOAT; PADDLE EQUIPMENT; PADDLES AND ACCESSORIES

Nemaxx 330
97 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
[
EN 13
]
Version: 1.2
KEN002ZB 02.02.2020
Inate inatable boat
1. Inatethesideairchambersbeforeinatingthekeelairchamber.Pumptheairchambersasfollows.
NOTE: Inserttheremovableseatbeforetheboatisfullyinated.
Install the bottom plates into the boat. See Installing the Floor Plates.
Unscrew the valve caps. Turn the caps a quarter turn counterclockwise.
Make sure that the valve shafts are positioned in the closed position. Push in the valve stem and turn it
to the closed position.
Connect the air hose adapter to the valve.
Startingatoneoftheairvalves,inatetheairchambersonebyonetoone-quarteroftheircapacity.
Repeatthisproceduretollallairchambersevenlyuntiltheyareinatedtotherecommended air
pressure of 0.25 bar (3.6 psi).
2. Unscrew the valve cap from the keel air chamber. Turn the cap a quarter turn counterclockwise. Make sure
that the valve stem is positioned in the closed position. Connect the air hose adapter to the valve. Inate
the keel to the recommended air pressure of 0.35 bar.
3. Afterination,tightenthevalvecapsrmly(turnclockwise).
NOTE: Always monitor the air pressure in the air chambers. The air volume in the air chambers expands as the
internalairtemperatureincreases.Thiscausestheairpressuretouctuatedependingonwatertemperature
andweatherconditions.Aftertheboathasbeeninatedtothecorrectairpressure,thepressuremaydropas
temperatures drop, requiring additional air. Direct sunlight or rising temperatures may cause the pressure to
become too high. In this case some air must be let out of the chamber until the recommended air pressure is
reached..
PADDLE EQUIPMENT
Nemaxx inflatable boats are available in standard version with paddles or with oars, oarlocks and a rudder seat.
Install the bottom plates into the boat. See Installing the Floor Plates.
Ensure that the seat is properly installed.
If the oars are not used, they must be secured in the clamps on the side of the boat.
Thearrangementoftheoarsonthisinatableboatensuresacomfortablepositionwhenrowing.Usethe
bench provided to make rowing as comfortable as possible.

Table of Contents