Nemaxx 330 - DEFLATE AND FOLDING; DEFLATING THE BOAT; FOLDING THE BOAT TOGETHER; TRANSPORT

[
EN ● 15
]
Version: 1.2
KEN002ZB 02.02.2020
● DEFLATE
NOTE: The boat must be clean and dry before being rolled up for storage.
Remove sand and dirt from boat skin.
Do not empty one chamber completely when discharging air from the boat.
Drain the air evenly from all chambers; this will prevent damage to the partitions in the boat.
● Placetheboatontheoor.
● Insertangerintothevalvetoopenthevalve.
● Drain some air from all chambers.
● Make sure that the valves remain open (so that the air can continue to escape when folded).
● Press evenly all over the boat to release as much air as possible.
● FOLDING THE BOAT TOGETHER
● Put the boat on the ground.
● If present, remove the bottom plates.
● Fold the boat towards the centre so that the whole boat is as wide as the mirror.
● Bring the end cones at the rear end of the side chambers to the middle of the mirror.
● Rollthemirrorforward.Thiswillhelptodeatetheair.Makesureallvalvesareopen.
● Iftheboatisfoldedinthisway,itwilltintothesuppliedbagfortransport.
● TRANSPORT
Make sure that there are no sharp parts where you want to lift the boat out of the water. Using the handles to
lift the boat
Iftheboatistowedbyanotherboat,theinatableboatmustbeempty.Removetheoutboardengine,fueltank
and equipment from the boat.
CAUTION
● When towing, no persons may be on board the towed boat.
● Check the towing line frequently.
● Regularly check the condition of the towed boat and ensure that it does not absorb any
water.
LIFTING THE BOAT OUT OF THE WATER
TOWING A BOAT