3
1.3. Operation Flow Chart
Checking the working area whether it is safe or not
Machine will start a 1-2 mins self-inspection process after
boot-up. The head will travel along in X&Y axis. It will
enter the operation page once finished.
Plz refer to the detailed programming tutorial in Page5
After making a programming file, there may exist several
programming issue, such as rotation issues of
components, thus a production testing is necessary for
solving issues.
Shut down the system via computer, then power off the
machine.
Disconnect the electricity supply after the system being
powered off.
Keep the machine clean, daily maintenance of the nozzles
to assures its high utility.
To Next Page
Loading...
