Chapter
GENERAL INFORMATION
NEOFOLD HS
VERSION: NF.HS-07-03/2015-GB 1-2
Conventions used 1.4
Conventional terms used 1.4.1
Machine: indicates the machine specified in 1.6. Identification data of the machine.
Frame: bearing structure of the machine.
Qualified personnel: people, who thanks to their knowledge and preparation and
experience, along with the knowledge of the relevant rules, safety requirements and
service conditions, are able to recognize and avoid any possible danger for the people,
and any damage to the media being worked and to the machine.
The descriptions of direction, sense and position (on the right of the machine, on the
left of the machine) refer to the position of the operator in front of the machine.
Conventional symbols used 1.4.2
Text in italics: indicates the title of a chapter, a section, a sub-section, a paragraph, a table
or an illustration of this manual, or another reference manual.
1 (generic number as an example): symbolic representation of a command device or
signal.
A (generic letter as an example): symbolic representation of a part of the machine.
Notes contain important information, and are pointed out after the text they refer to.
The danger symbols indicate those procedures which, if not respected, could cause
physical damages to the operator. The manufacturer cannot be held responsible for any
damages to people due to noncompliance with these norms.
The warning symbols indicate those procedures which, if not respected, could damage the
machines or the devices connected to it. The manufacturer cannot be held responsible for
any damages to objects due to the noncompliance with these norms.
To Next Page
Loading...
