Chapter
INSTALLATION
NEOFOLD HS
VERSION: NF.HS-07-03/2015-GB 5-9
If an alarm code is shown on the display, refer to section “07. ALARM
MESSAGES/INDICATIONS” of this manual and follow the procedures indicated.
NOTE: If the machine has to be transported, follow the unpacking operations described
above in the reverse order.
Storage 5.4
The indications contained in this section must be followed during the periods of temporary
storage of the machine which could take place in the following situations:
When the machine is not installed immediately after it is delivered.
When the machine is disconnected and stored, before being relocated
For as much as possible the machine must be stored in such a way that it is not
accessible for unauthorized people, it must be protected from damages due to dust,
humidity, heat, cold, sun rays or substances that may corrode it.
Storage areas must not be near dangerous areas.
Characteristics 5.4.1
Temperature between: from -5°C to +55°C.
Humidity: from 30 % to 95% without condensate. Ideal humidity ~55%, with max.
temperature 40°C.
Proper natural and/or artificial illumination.
Proper protection from atmospherics.
Adequate space to carry out the hoisting and transportation operations in a safe and
easy way, see chapter Transportation conditions 5.2.1.
Horizontal surface with a capacity higher than the mass of the machine.
Adequate space to carry out the ordinary maintenance and technical operations, see
chapter Work space 3.1.1.
To Next Page
Loading...
