Nespresso Gemini CS220 - Page 35

Towerservicemanual
35
I N S T A L L A T I O N
4. Pullcableofcupheaterthroughholeindrawer.Theninsertcupheaterindrawer.
5. Pullcablethroughcablesupportsleeveofstrainrelief(4).
6. Screwstrainreliefondrawer.
7. Mountedgeprotection(5).
8. Stickvelcrostrips(6)tobottomofpowersupplyandsheetmetalsupport.Fasten
powersupplywithvelcrostrips(7).
9. Installpowercord.
10. Insertmiddledrawerinbasecabinet.
11. Rollupexcessivecablelengthandfixitwithacabletie(8).
12. Connectcupheatertopowersupply.
Thedraweris
equippedwiththe
mountingholes
already.
Drawoutmiddle
drawerfullyand
checkifcablelenght
betweenpowersupplyand
cupheaterissufficient.