Ness IQ - Page 54

Digital Video Recorder for Ness IQ-
Series
 In Pan/Tilt mode, the
icon is displayed on the bottom of the screen.
 Following is the key
usage found in Pan/Tilt mode.

To use a mouse in Pan/Tilt mode, please move the cursor to the lower portion near the center of the screen. To use front
button in Pan/Tilt mode, please push setup button.

To activate PTZ control OSD menu, user must move the cursor to the bottom right portion of the screen.
will show as follows:

To save current camera number, select Preset No and

To move to preset, select preset No and

Available 1 ~ 255 Preset numbers can saved it depends on camera specification.
 As explained earlier in 4.4.2.,
press Menu button to pop
items.
- Since these functions make use of a
memory function of the camera itself, user should set them in Camera OSD.
-
Once user completes the setup, close the Camera OSD menu.
-
User can conveniently use Tour and Pattern functions simply by clicking Tour and Pattern buttons.
- Particulars on how to setu
p each function on OSD Menu are found in the manual of a corresponding camera.
NOTE
Suppose a command for using Tour function is 71 ~ 79 + P
button to benefit the Tour function (70 + 1~9).
Series
960H & SDI DVR
icon is displayed on the bottom of the screen.
usage found in Pan/Tilt mode.
Key Function
Up/Down/Left/Right rotation
Zoom out
Zoom in
Focus near
Focus far
Iris Close
Iris Open
Save Preset
Go to the Preset
Go to OSD main menu
Run Group Tour 1~9
Run Pattern 1~9
To use a mouse in Pan/Tilt mode, please move the cursor to the lower portion near the center of the screen. To use front
button in Pan/Tilt mode, please push setup button.
To activate PTZ control OSD menu, user must move the cursor to the bottom right portion of the screen.
To save current camera number, select Preset No and
button click.
To move to preset, select preset No and
button click.
Available 1 ~ 255 Preset numbers can saved it depends on camera specification.
press Menu button to pop
-
up PTZ camera OSD setup screen and set up Tour and Pattern
memory function of the camera itself, user should set them in Camera OSD.
Once user completes the setup, close the Camera OSD menu.
User can conveniently use Tour and Pattern functions simply by clicking Tour and Pattern buttons.
p each function on OSD Menu are found in the manual of a corresponding camera.
Suppose a command for using Tour function is 71 ~ 79 + P
reset
and if you had set Tour to 70, use Preset No: 1 ~ 9 + Tour
button to benefit the Tour function (70 + 1~9).
Page
54
To use a mouse in Pan/Tilt mode, please move the cursor to the lower portion near the center of the screen. To use front
To activate PTZ control OSD menu, user must move the cursor to the bottom right portion of the screen.
A key pad control
up PTZ camera OSD setup screen and set up Tour and Pattern
memory function of the camera itself, user should set them in Camera OSD.
User can conveniently use Tour and Pattern functions simply by clicking Tour and Pattern buttons.
p each function on OSD Menu are found in the manual of a corresponding camera.
and if you had set Tour to 70, use Preset No: 1 ~ 9 + Tour