10
NESS R8 CONTROL PANEL - USER MANUAL
OPERATION
The control panel must be armed to enable
detection zones.
Arming the panel starts the exit delay timer. All
zones are inactive during this time and become
fully armed once the exit delay time expires.
(End of exit delay is signalled by 3 beeps from
the keypad beeper).
The factory default exit delay time is 60 seconds.
This can be changed if necessary, see the
programming section in this manual.
The panel must initially be in the disarmed state
and not in Program, Monitor, Memory or
Exclude modes.
Note: If the panel is already in alarm, you must
first silence the alarm before you can arm.
At the end of the exit time, all zones should be
Sealed. If any are Unsealed, the onboard siren
and the external siren, (if installed), will sound
a lower volume tone for 2 seconds as a warning
that those zones have been automatically
excluded. For maximum security, you should
return, disarm the panel, check the premises
and then Arm again. Continual warnings could
mean that a detector is faulty and may have to
be manually excluded.
If the auto-exclude option is disabled by your
installer and a zone is unsealed at the end of
exit time, the siren will sound for 5 minutes,
(5 minutes is the factory default siren duration).
x 1
[User Code]
ARMING
...or
To Arm the system using the onboard keypad,
press ARM followed by a valid user code, followed
by the E key.
To Arm the system using a Radio Key
press the ON button.
If Siren Chirps have been enabled by
your installer, the strobe light output will
flash and the onboard siren will 'chirp' once
to indicate successful arming.
The Arming Shortcut is enabled by default, this
allows arming without having to enter your user
code. (The Arming Shortcut can be disabled by
your installer).
To Next Page
Loading...
Need help?
General
