12
NESS R8 CONTROL PANEL - USER MANUAL
OPERATION
When you enter the protected premises
through a delay zone, the keypad will sound
continuous beeps as a reminder to disarm.
The panel must be disarmed before the entry
delay time expires, otherwise the alarm will
sound.
If using a Radio Key, you can disarm from
outside the premises without having to enter
any protected zones.
The factory default entry delay time is 20
seconds. This can be changed if necessary,
see the programming section in this manual.
If you make a mistake in entering your code,
press the E button and try again. Five incorrect
code attempts will cause an alarm.
[User Code]
DISARMING
To Disarm the system using the onboard keypad,
enter a valid user code, followed by the E key.
To Disarm the system using a Radio Key
press the OFF button.
If Siren Chirps have been enabled by
your installer, the strobe light output will
flash and the onboard siren will 'chirp' three
times to indicate successful disarming.
Sirens and strobe output, (if running), will be reset
on disarming.
x 1
To Next Page
Loading...
Need help?
General
