Netafim Orbia GrowSphere MAX User Manual

Rev 01
|
GrowSphere
™
MAX User Manual
69
|
Controller Configuration
GrowSphere
Operating System
5.4.5 Configuring Valves
The system displays a row for each of the valves defined in the Mainline tab. Perform the
following steps to configure the valves names and other parameters:
z
Device Type: Indicates the device type. In this
tab, all devices are defined as valves.
z
Device #: Indicates the valve number.
z
Source: Irrigation main line to which the valve
is connected.
z
Name: The system set a default name. It is
suggested to type here a descriptive name for
the valve.
z
Flow (m³/h): Set the valve's nominal flow rate.
z
Area (ha): Define the area (in hectares) of the
irrigation block that is allocated to the valve.
z
Assigned: Indicates if the valve was assigned
to an output module.
If the valve is disabled the valve line appears
gray.
z
Module: The controller module name and slot
number to which the device is connected.
z
DO (Digital Output): The module's output
port number to which the device is
connected.
3. Tap the Configuration
tab
1. Tap the Configuration
button
4. Tap the Valves tab
5. Define the valve parameters:
2. Select Settings and type
your credentials
SAFETY
QUICK START
INTRODUCTION
INSTALL ATION
CONTROLLER
OPERATION
CONTROLLER
CONFIGURATION

Netafim Orbia GrowSphere MAX Specifications

General

Brand	Netafim
Model	Orbia GrowSphere MAX
Category	Controller
Language	English