NetApp StorageGRID Webscale SG6000 Series User Manual

Information needed Your value
MAC address for the Admin Network port
Note: The MAC address label on the front of
the SG6000-CN controller lists the MAC
address for the BMC management port. To
determine the MAC address for the Admin
Network port, you must add 2 to the
hexadecimal number on the label. For
example, if the MAC address on the label
ends in 09, the MAC address for the Admin
Port would end in 0B. If the MAC address on
the label ends in (y)FF, the MAC address for
the Admin Port would end in (y+1)01. You
can easily make this calculation by opening
Calculator in Windows, setting it to
Programmer mode, selecting Hex, typing the
MAC address, then typing + 2 =.
DHCP-assigned IP address for the Admin
Network port, if available after power on
Note: You can determine the DHCP-assigned
IP address by using the MAC address to look
up the assigned IP.
• IPv4 address (CIDR):
• Gateway:
Static IP address you plan to use for the
appliance Storage Node on the Admin Network
Note: If your network does not have a
gateway, specify the same static IPv4 address
for the gateway.
• IPv4 address (CIDR):
• Gateway:
Admin Network subnets (CIDR)
Table 3: Information needed to connect and configure the 10/25-GbE ports on the
SG6000-CN controller
The four 10/25-GbE ports on the SG6000-CN controller connect to the StorageGRID Webscale Grid
Network and the optional Client Network.
Information needed
Your value
Link speed Choose one:
• 10 GbE (default)
• 25 GbE
Port bond mode Choose one:
• Fixed (default)
• Aggregate
Switch port for port 1 (Client Network for Fixed
mode)
Switch port for port 2 (Grid Network for Fixed
mode)
20 | Hardware Installation and Maintenance Guide for SG6000 Appliances

NetApp StorageGRID Webscale SG6000 Series Specifications

General

Brand	NetApp
Model	StorageGRID Webscale SG6000 Series
Category	Server
Language	English