The login page for SANtricity System Manager appears.
c. Go to step
3
.
2. If the network does not use a DHCP server (or if an IP address was not acquired from the DHCP
server):
a. Connect the service laptop directly to management port 2 on controller A, using an Ethernet
cable.
Controller A is the top E2800 controller in the E2860 controller shelf.
b. Configure the IP address and subnet mast for the Ethernet port on the service laptop:
• IP address: 192.168.129.100
• Subnet mask: 255.255.255.0
c. Open a web browser on the service laptop, and enter this URL:
https://192.168.129.101
The login page for SANtricity System Manager appears.
3.
Set or enter the administrator password.
Note: SANtricity System Manager uses a single administrator password that is shared among
all users.
Attention: Do not complete the Set Up wizard for a StorageGRID Webscale appliance.
The Set Up wizard appears.
4. Click Cancel to close the wizard.
Do not complete the Set Up wizard for a StorageGRID Webscale appliance.
The SANtricity System Manager home page appears.
36
| Hardware Installation and Maintenance Guide for SG6000 Appliances
To Next Page
Loading...
