5. For step 1 of the Configure Management Ports wizard, make sure Port P1 is selected, and click
Next.
6. For step 2 of the Configure Management Ports wizard, configure the network settings for port 1
on controller B.
a. From the Speed and duplex mode drop-down list, make sure Auto-negotiate is selected.
You must also make sure the Ethernet switch for the management network is set to
autonegotiate. Connectivity issues might occur if automatic negotiation is selected in
SANtricity System Manager but not set for the Ethernet switch.
b. Depending on your network configuration, select Enable IPv4, Enable IPv6, or both.
7. If you selected Enable IPv4:
a. Click Next.
b. Make sure Manually specify static configuration is selected.
c. Change the IP address of port 1 to a routable management IP address, subnet mask, and
gateway.
38 | Hardware Installation and Maintenance Guide for SG6000 Appliances
To Next Page
Loading...
Need help?
General
