NetComm Wireless AC1200 WiFi Gigabit Router with Voice
Caller ID
The Caller ID page enables you to configure whether your Caller ID is sent when receiving an inbound call (If supported by your VoIP
service and your PSTN handset).
Figure 59 - Caller ID
Select whether to show or hide the caller ID.
Table 24 - Caller ID
Click Save to save your settings or Undo to discard the settings entered.
Flash time
The Flash time page enables you to configure the minimum and maximum time a hook flash signal can occur for the router to
recognise it.
Figure 60 - Flash time setting
This setting should not need to be changed unless directed to do so. Click Save to save your settings or Undo to discard the
settings entered.
Call waiting
The Call Waiting page enables you to use call waiting with your VoIP service (If supported by your VoIP service).
Figure 61 - Call waiting
Select to Enable or Disable the call waiting feature on the router.
Table 25 - Call waiting
Click Save to save your settings or Undo to discard the settings entered.
To Next Page
Loading...
Need help?
General
