NetComm NF17ACV

32
NetComm Wireless NF17ACV User Guide
www.netcommwireless.com
v1.0
LAN
IPv4 Autoconfig
The LAN window allows you to modify the settings for your local area network (LAN).
The following options are available to configure:
PARAMETER
DEFINITION
IP Address
Enter the Local IP Address to use for the NF17ACV.
Subnet Mask
Enter the subnet mask to define the subnet of the Local Network.
Enable IGMP Snooping
Enable IGMP Snooping and select the IGMP Snooping mode to use. Standard: allow all multicast traffic to
LAN clients. Blocking: only allow multicast subscribed clients to receive multicast packets.
Enable LAN side Firewall
Enable the LAN side firewall to restrict traffic between LAN hosts.
Enable DHCP Server
Select to enable or disable the DHCP server and enter the start and end address for the DHCP IP Address
pool.
Enable DHCP Server Relay
Disabled DHCP server, and relay all request to external server specified by the IP address.
Configure the second IP Address
This option enables you to set a secondary IP Address for the NF17ACV
You can also reserve DHCP Addresses for specific hosts as shown below: