What to do if I can't access NetComm NF17ACV Modem web configuration pages?
- SSamantha PenningtonAug 2, 2025
To access the web configuration pages of your NetComm modem, first check that remote administration access is enabled. If you've set up an inbound packet filter, ensure your computer's IP address matches it. For LAN access, your computer's and the modem's IP addresses must be on the same subnet, which you can verify on the Network Setup page. If you've changed the modem's IP address, use the new address in your web browser. If problems persist, reset the modem to factory defaults by pressing the reset button for 3 seconds until the Power LED blinks, then navigate to 192.168.20.1 and log in with the username and password 'admin'.