To Next Page

To Previous Page

14 – 3G10WV HSPA Wi-Fi Router with Voice

3.2 TCP/IP Settings

DHCP Mode

When your Router powers up, the Dynamic Host Conﬁguration Protocol (DHCP) server (on the device) will

start automatically. To set your PC for DHCP mode, check the Internet Protocol properties of your Local Area

Connection. You can set your PC to DHCP mode by selecting Obtain an IP address automatically in the dialog

box shown below.

STATIC IP Mode

To conﬁgure your Router manually, your PC must have a static IP address within the Router’s subnet. The

following steps show how to conﬁgure your PC IP address using subnet 192.168.1.x. The following assumes

you are running Windows XP.

1: From the Network Connections window, open Local Area Connection (You may also access this screen by

double-clicking the Local Area Connection icon on your taskbar). Click the Properties button.

2: Select Internet Protocol (TCP/IP) and click the Properties button. The screen should now display as below.

Change the IP address to the domain of

192.168.1.x

(1<x<254) with subnet mask of 255.255.255.0. Set

the default router and DNS server to the router’s IP address.

NOTE: The IP address of the router is 192.168.1.1 (default), so the PC must be set with a different IP. In the case below, the PC’s IP

address is set as 192.168.1.2

3: Click OK to submit the settings.

NetComm ROUTER WITH VOICE 3G10WV User Manual

Questions and Answers: