NetComm Wireless Router NB504 User Manual

YML864 Rev1 NB504 User GuideNB504 User Guide
www.netcomm.com.au 35
5.5.1 Wireless Settings
The basic settings for the wireless network are set on this page, figure 5-15:
Figure 5-15 Wireless Settings
• SSID - Enter a value of up to 32 characters. The same name (SSID) must be assigned to all wireless
devices in your network. The default SSID is Wireless, but it is recommended strongly that you change
your networks name (SSID) to a different value. This value is case-sensitive. For example, NETCOMM is
NOT the same as Netcomm.
• Region - Select your region from the pull-down list. This field specifies the region where the wireless
function of the router can be used. It may be illegal to use the wireless function of the router in a region
other than one of those specified in this field. If your country or region is not listed, please contact your
local government agency for assistance.
The default region is Australia. When you select your local region from the pull-down list, Click the Save
button, then the Note Dialog appears. Click OK.
Note Dialog

NetComm Wireless Router NB504 Specifications

General

Brand	NetComm
Model	Wireless Router NB504
Category	Wireless Router
Language	English