5.9.2 ARP List
To manage the computer, you could observe the computers in the LAN by checking the relationship of MAC
address and IP address on the ARP list, and you could configure the items on the ARP list also. This page
displays the ARP List; it shows all the existing IP & MAC Binding entries (shown in Figure 5-46).
Figure 5-46ARP List
• MAC Address - The MAC address of the controlled computer in the LAN.
• IP Address - The assigned IP address of the controlled computer in the LAN.
• Status - Enabled or Disabled of the MAC address and IP address binding.
• Configure - Load or delete item.
• Load - Load the item to the IP & MAC Binding list.
• Delete - Delete the item.
Click the Bind All button to bind all the current items, available after enable.
Click the Load All button to load all items to the IP & MAC Binding list.
Click the Refresh button to refresh all items.
Note: An item could not be loaded to the IP & MAC Binding list if the IP address of the item has been loaded before. Error warning will
prompt as well. Likewise, “Load All” only loads the items without interference to the IP & MAC Binding list.
To Next Page
Loading...
Need help?
General
