NETGEAR C6300BD User Manual

Configure Advanced Features
130
AC1900, N900, and N450 WiFi Cable Data Gateways
The following table describes the fields on the Port Triggering - Services screen.
Field Description
Service
Service Name Enter a descriptive name.
Service User From the menu, select if any internal IP address can connect to the service or
application or only a single IP address can connect. If you select Single address
from the menu, enter the IP address.
Service Type From the menu, select the correct type of protocol for the service or application
(TCP or UDP).
Triggering Port Enter the internal starting port number for the service or application. This number
represents the outbound traf
fic port that must cause the inbound ports (see
Inbound Connection later in this table) to be opened.
Triggering Ending Port If the service or application uses a single triggering port, enter the same port
number that you enter in the T
riggering Port field.
If the service or application uses a range of triggering ports, enter the ending port
number of the range.
Inbound Connection
Starting Port Enter the starting port number for the inbound connection. This number represents
the inbound traf
fic port that is triggered open by the triggering port.
Ending Port If the service or application uses a single ending port for the inbound connection,
enter the same port number that you enter in the Starting Port field.
If the service or application uses a range of ports for the inbound connection, enter
the ending port number of the range.
9. Click the Apply button.
The service or application is added to the Port Triggering Portmap Table. The Enable
check box is selected automatically
.
10. In the Port Triggering section, select how the cable data gateway applies port triggering:
• Per Schedule. Port triggering is enabled according the schedule that you must select
from the menu.
For more information, see Schedule When Features Are Active on page 68.
• Always. Port triggering is always enabled.
Note: By default, the Never radio button is selected and port triggering is
disabled, even if you specified services and applications in the table.
11. Click the Apply button.
Your settings are saved.

NETGEAR C6300BD Specifications

General

Brand	NETGEAR
Model	C6300BD
Category	Gateway
Language	English