To Next PageTo Next PageWhat to do if NETGEAR Modem cannot access the Internet but the Internet LED lights green?
If the Internet LED on your NETGEAR Modem is lit green but you still cannot access the internet, ensure that the cable MAC address or device MAC address of your modem is registered with your cable Internet provider.
Why is the Power LED on my NETGEAR CM1000 Modem red?
If the Power LED on your NETGEAR Modem lights red, it might be overheating. Here's what to do: * Disconnect the power adapter. * Wait a couple of minutes for the modem to cool down. * Ensure the modem is in a vertical position with good ventilation. * Reconnect the power adapter.
How to troubleshoot NETGEAR CM1000 Modem login issues?
If you cannot log in to your NETGEAR Modem, here are a few things to check: 1. If using an Ethernet cable, verify the connection. 2. Ensure your computer's IP address is in the range of 192.168.100.2 to 192.168.100.254. 3. Enable Java, JavaScript, or ActiveX in your browser; refresh the page if using Internet Explorer. 4. Restart your browser. 5. Use the correct login: username 'admin' (lowercase) and default password 'password'. 6. Click 'Apply' when changing settings. 7. Refresh the web browser to see changes.
What to do if the Internet LED is off on a NETGEAR CM1000?
If the Internet LED is off on your NETGEAR Modem, and it's connected to the cable wall jack, ensure the coaxial cable connections are secure at both the modem and the wall jack. Also, confirm that your cable Internet provider has provisioned your service and that the signal quality is sufficient. Remove any extra splitters on your cable line and run a “home run” back to where the cable enters your home.
What to do if Ethernet LED is off on NETGEAR CM1000?
If the Ethernet LED is off on your NETGEAR Modem, even with a powered-on device connected, verify that the Ethernet cable connections are secure at both the modem and the connected device (computer, router, or WiFi router). Also, make sure that the connected hub or computer is powered on and that you are using the correct cable.
What to do if all LEDs stay on NETGEAR CM1000 Modem?
To resolve the issue where all LEDs stay on your NETGEAR Modem, try clearing the modem's configuration to its factory defaults. If the problem continues, it might indicate a hardware issue.
How to fix NETGEAR Modem when all LEDs are off?
If all LEDs are off when your NETGEAR Modem is plugged in, ensure the power cord is correctly connected to both the modem and a functioning power outlet. Verify that you are using the 12 VDC, 2.5A power adapter from NETGEAR designed for this product. If the issue persists, it could be a hardware problem.
General| DOCSIS Version | 3.1 |
|---|---|
| Ethernet Ports | 1 x Gigabit Ethernet |
| Channel Bonding | 32x8 |
| Device Type | Cable Modem |
| IPv6 Support | Yes |
| Compatibility | Xfinity, Spectrum, Cox |
| Weight | 1.1 lbs |
| Max Download Speed | Up to 1 Gbps |
| Max Upload Speed | Up to 1 Gbps |
