Wireless Cable Voice Gateway Model CVG834G Reference Manual
Installing the Gateway 1-3
v2.0, November 2007
The Gateway Rear Panel
The label on the bottom of the gateway identifies the connections on the rear panel.
The rear panel includes the following connections, viewed from left to right.
• Wireless Antenna. The gateway ships with the wireless antenna already attached.
• Power. AC power adapter input.
• USB port. If the USB driver is installed, you can connect a local computer to this port.
• Four Ethernet LAN ports. Use these ports to connect local computers.
• Reset button. Resets the gateway to its factory defaults.
• Coaxial cable connector. Attach coaxial cable to the cable service provider’s connection.
• Two Voice/Phone ports. With VoIP service, connect one or two handsets to these ports.
Installing the Voice Gateway
Installation is a four-part process. Complete the installation in this order:
1. Check the Installation Requirements. See “Installation Requirements”.
2. Connect the Gateway. See “Connecting the Wireless Voice Gateway”.
3. Log in to the Gateway. See “Logging In to the Wireless Voice Gateway”.
Figure 1-2
Reset button
Wireless antenna
AC power adapter input
Four Ethernet LAN ports to connect local
computers
Coaxial cable to your cable
USB port
service provider
Voice/phone ports to
connect handsets
To Next Page
Loading...
