Wireless Cable Voice Gateway Model CVG834G Reference Manual
Installing the Gateway 1-5
v2.0, November 2007
4. If you have VoIP service, connect the phone to Voice Port 1. If your service includes a second
line, you can connect that phone to Voice Port 2.
5. Verify the following:
• The power light is lit.
• The cable link light is solid green, indicating a link has been established to the cable
network.
• If you connected VoIP lines, the Voice port lights blink.
USB Connection
To connect a computer to the USB port on the gateway:
1. You must install the USB driver. Insert your NETGEAR CD into the CD drive of your
computer.
a. Connect the USB cable to your gateway and plug in the AC power for the gateway.
b. Use the USB cable to connect your computer to the gateway.
c. The Found New Hardware Windows installation wizard prompts for the drivers.
d. Browse to the NETGEAR CD and install the USB driver by clicking through the
Windows wizard prompts.
Note: The USB connection option is only available for Windows PCs. Also, Windows 95
does not support USB without special operating system upgrades and patches.
Figure 1-3
To Next Page
Loading...
