A-1
v2.0, November 2007
Appendix A
Default Settings and Technical Specifications
Factory Default Settings
You can use the reset button located on the front of your device to reset all settings to their factory
defaults. This is called a hard reset.
• To perform a hard reset, push and hold the reset button for approximately 5 seconds (until the
Test LED blinks rapidly). Your device will return to the factory configuration settings shown
in the table below.
• Pressing the reset button for a shorter period of time will simply cause your device to reboot.
Feature Description
Smart Wizard Enabled
Gateway Login
Gateway login URL
http://192.168.0.1
Login name admin
Password password
Internet Connection
WAN MAC address Use default hardware address
MTU Size 1500
Local Network
LAN IP Address (aka Gateway IP address) 192.168.0.1
Gateway subnet mask 255.255.255.0
DHCP server Enabled
LAN IP starting IP address 192.168.0.10
LAN IP ending IP address 192.168.0.19
Static IP address pool 192.168.0.2 to 192.168.0.9 inclusive
To Next Page
Loading...
Need help?
General