Wireless Cable Voice Gateway Model CVG834G Reference Manual
1-6 Installing the Gateway
v2.0, November 2007
2. Connect your computer to the USB port on the gateway.
3. Plug in your gateway and wait about 30 seconds for the lights to stop blinking.
4. Verify the following:
• The power light is lit.
• The cable link light is solid green, indicating a link has been established to the cable
network.
• The USB light is lit.
Logging In to the Wireless Voice Gateway
To log in to the gateway:
1. Using the computer that you first used to access your cable modem Internet service, connect to
the gateway by typing http://192.168.0.1 in the address field of your Internet browser.
The gateway default user name is admin, with the default password of password, both in
lower-case letters. When prompted to log in, enter the user name and password. You are now
connected to the gateway.
Note: To connect to the gateway, your computer must be configured to use DHCP. For
instructions on how to do this, see the link to “Preparing a Computer for Network
Access:” in Appendix B.
Figure 1-4
http://192.168.0.1
To Next Page
Loading...
