14
If your USB device needs a power supply, you have to use it when
you connect the USB device to the USB port. It might take up to 2
minutes before the USB drive is ready for sharing after you connect it.
T
o access your USB device:
On Windows systems, use any of these methods:
• Sel
ect Start > Run and enter \\readyshare in the dialog box.
Click OK.
• Open
Explorer or Safari and enter \\readyshare in the address
bar.
• Open
My Network Places, and enter \\readyshare in the address
bar.
On Mac systems, do this:
1. Sel
ect Go > Connect to Server.
2. Enter smb://read
yshare as the server address.
3. Cl
ick Connect.
The readyshareconnect.exe file (fo
r Windows) is available to
download here: www.netgear.com/readyshare
ReadySHARE Printer
The USB Control Center utility allows you to control a shared USB
device from the computer that is connected to the USB port on your
router. The utility allows you to control a printer.
Install the utility on each computer
on your network from which you
want to control the device. You can download this utility at
www.netgear.com/readyshare.
To Next Page
Loading...
