Reference Manual for the ADSL Modem Wireless Router DG834G
8-30 Virtual Private Networking
v1.3, March 2007
3. Click on VPN Status (Figure 8-29) to get the Current VPN Tunnels (SAs) screen
(Figure 8-30). Click on Connect for the VPN tunnel you want to activate.
Activate the VPN Tunnel by Pinging the Remote Endpoint
To activate the VPN tunnel by pinging the remote endpoint (e.g., 192.168.3.1), do the following
steps depending on whether your configuration is client-to-gateway or gateway-to-gateway:
• Client-to-Gateway Configuration—to check the VPN Connection, you can initiate a request
from the remote PC to the DG834G v3’s network by using the “Connect” option in the
NETGEAR ProSafe menu bar. The NETGEAR ProSafe client will report the results of the
attempt to connect. Since the remote PC has a dynamically assigned WAN IP address, it must
initiate the request.
To perform a ping test using our example, start from the remote PC:
a. Establish an Internet connection from the PC.
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type
ping -t 192.168.3.1 and then click OK.
Figure 8-30
Note: This section uses 192.168.3.1 for an example remote endpoint LAN IP address.
To Next Page
Loading...
