FS728TP Smart Switch Software Administration Manual
4-54 Configuring Switching Settings
v1.1, September 2009
4. Select the MAC Address duration period Status from the list in the provided field in the first
row.
5. Click APPLY to update the device.
Dynamic Addresses
The Dynamic Addresses screen contains information about the aging time before a dynamic MAC
address is erased.
To configure the Dynamic MAC Address table:
1. Click Switching > Address Table > Advanced > Dynamic Addresses. The Dynamic
Addresses screen displays:
The Dynamic Addresses screen contains the following field:
• Address Aging – Enter the amount of time the MAC address remains in the Dynamic
MAC Address table before it is timed out if no traffic from the source is detected. The
range is 10 - 630 seconds. The default value is 300 seconds.
2. Enter the Address Aging in the provided field in the first row.
3. Click APPLY to update the device.
Figure 4-30
To Next Page
Loading...
