NETGEAR FVS336Gv3 - Page 304

Customize Firewall Protection
304
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
9. Click the Apply button.
Your settings are saved. The new bandwidth profile is added to the List of Bandwidth
Profiles table.
10. In the Bandwidth Profiles section, select the Yes radio button under Enable Bandwidth
Profiles?
By default, the No radio button is selected.
11. Click the Apply button.
Your settings are saved.
Change a Bandwidth Profile
The following procedure describes how to change an existing bandwidth profile.
 To change a bandwidth profile:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
Inbound Maximum
Bandwidth
The inbound maximum allowed bandwidth in Kbps. The maximum allowable
bandwidth is 100,000 Kbps and you cannot configure less than 100 Kbps. The VPN
firewall does not provide a default setting.
Outbound Minimum
Bandwidth
The outbound minimum allocated bandwidth in Kbps. The VPN firewall does not
provide a default setting.
Outbound Maximum
Bandwidth
The outbound maximum allowed bandwidth in Kbps. The maximum allowable
bandwidth is 100,000 Kbps and you cannot configure less than 100 Kbps. The VPN
firewall does not provide a default setting.
Type From the Type menu, select the type for the bandwidth profile:
• Group. The profile applies to all users, that is, all users share the available
bandwidth.
• Individual. The profile applies to an individual user, that is, each user can use
the available bandwidth. In the Maximum Number of Instances field, specify
the maximum number of class instances.
Maximum Number of
Instances
If you select Individual from the Type menu, you must specify the maximum
number of class instances that can be created by the individual bandwidth profile.
Note: If the number of users exceeds the configured number of instances, the same
bandwidth is shared among all the users of that bandwidth profile.
Setting Description