User Manual for the NETGEAR 10/100/1000 Mbps CardBus Adapter GA511
Basic Setup 3-3
If you are installing more than one GA511 Gigabit CardBus Adapter, you must perform these steps
for each card.
Basic Installation Instructions
Use the procedure below for installation on a Windows XP, 2000, 98SE 2nd edition, or Me system.
FIRST, INSTALL THE GA511 SOFTWARE.
a. Power on your notebook, let the
operating system boot up completely,
and log in as needed.
b. Insert the NETGEAR Adapter Resource
CD into your CD-ROM drive. The
Adapter Resource CD main page will
load.
c. From the Windows Start menu, select
Run. The Run dialog box opens.
d. Enter the path to the GA511 setup.exe
file on the CD. For example, if your
CD-ROM is drive D, enter
D:\GA511\setup as the path.
Then, click OK.
e. Follow the InstallShield Wizard steps,
click Finish when done, and if prompted,
restart your computer.
Now, the GA511 driver and utility software
are installed.
Adapters Resource CD
Windows Start > Run
To Next Page
Loading...
