Factory Default Settings
You can return the switch to its factory settings. Use the end of a paper clip or some
other similar object to press and hold the Factory Defaults button on the front panel
of the switch for four seconds. The switch resets and returns to the factory settings that
are shown in the following table.
Table 6. Factory default settings
SettingFeature
passwordSwitch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)IP address
255.255.255.0Subnet mask
EnabledDHCP mode
EnabledUPnP
EnabledBonjour
EnabledNSDP
EnabledIGMP snooping
None configuredLAGs
Disabled. If enabled, by default, all ports are members of VLAN 1.VLANs
Disabled. If enabled, by default, the Class of Service (CoS) value is 6.Voice VLAN
Enabled802.1p/DSCP-based QoS
DisabledPort-based QoS
DisabledRate limiting
DisabledBroadcast filtering
EnabledLoop prevention
DisabledPower saving mode
AutonegotiationPort speed
DisabledFlow control
DisabledPort mirroring
User Manual78Factory Default Settings and
Technical Specifications
8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS110EMX