NETGEAR GS110T - Chapter 2 Physical Description; GS110 T Front-Panel Configuration

11
2
2. Physical Description
This chapter describes the NETGEAR GS110T Smart Switch hardware features. Topics
include:
• GS110T Front-Panel Configuration
• LED Designations
• Device Hardware Interfaces
GS110T Front-Panel Configuration
The GS110T has eight 10/100/1000 Mbps autosensing and two 1000 Mbps SFP Gigabit
Ethernet switching ports. Each RJ-45 port is capable of sensing the line speed and
negotiating the duplex mode with the link partner automatically.
Figure 2 illustrates the front panel of the NETGEAR GS110T Smart Switch:
Power/Status LED
10/100/1000 Mbps Ethernet Ports 1000M SFP Ports
Link/Speed/ACT Status LEDs
Figure 2. GS110T Front Panel
The GS110T front panel contains the following:
• Eight RJ-45 connectors for 10/100/1000 Mbps autosensing Gigabit Ethernet switching
ports
• Two 1000M SFP Gigabit Ethernet switching ports
• Reset button to restart the device
• Recessed default reset button to restore the device back to the factory defaults
• Link, Speed, and Activity LEDs for each port
• Power and Status LED