NETGEAR GS110T User Manual

17
4
4. Installation
This chapter describes the installation procedures for your NETGEAR GS110T Smart
Switch. Switch installation involves the following steps:
Step 1: Preparing the Site
Step 2: Installing the Switch
Step 3: Checking the Installation
Step 4: Connecting Devices to the Switch
Step 5: Applying AC Power
Step 6: Managing the Switch using a Web Browser or the PC Utility
Step 1: Preparing the Site
Before you install the switch, ensure the operating environment meets the site requirements
in
Table 3.
Table 3. Site Requirements
Characteristics Requirements
Mounting • Desktop installations - Provide a flat table or shelf surface.
• Wall-mount installations - Wall-mount: select a location. You also need the mounting
screws supplied with your switch.
Access Locate the switch in a position that allows access to the front panel RJ-45 ports, view the
front panel LEDs, and access the power connector.

NETGEAR GS110T Specifications

General

Model	GS110T
Managed	Yes
Power over Ethernet (PoE)	No
Category	Switch
MAC Address Table Size	8000 entries
Jumbo Frame Support	9K packet size
VLAN Support	Yes
Quality of Service (QoS)	Yes
Operating Temperature	0° to 40° C (32° to 104° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Humidity	90% maximum relative humidity, noncondensing
Voltage	100-240V AC, 50-60Hz