Table 2. Model GS310TP LEDs on the front panel (Continued)
DescriptionLED
Off. No link is established.
Solid green. A valid 1 Gbps link is established.
Blinking green. The port is transmitting or receiving packets at 1 Gbps.
Solid yellow. A valid 10 Mbps or 100 Mbps link is established.
Blinking yellow. The port is transmitting or receiving packets at 10 Mbps or 100
Mbps.
RJ-45 left LED
Link, speed, and activity for
Ethernet ports 1 to 8
Off. The port is not delivering PoE power.
Solid green. The port is delivering PoE power.
Solid yellow. A PoE fault occurred.
RJ-45 right LED
PoE status for Ethernet ports
1 to 8.
Off. No SFP module link is established.
Solid green. A valid 1 Gbps link is established.
Blinking green. The SFP fiber port is transmitting or receiving packets at 1 Gbps.
Link/ACT LED
Link and activity for SFP fiber
ports 9 and 10
Model GS310TP: SFP ports for fiber connectivity
To enable fiber connections on model GS310TP, SFP fiber ports accommodate standard
small form-factor pluggable (SFP) gigabit interface converters (GBICs, also referred to
as transceiver modules). GBICs are sold separately from the switch.
Model GS310TP supports the NETGEAR SFP transceiver modules that are listed in the
following table.
Table 3. Supported SFP transceiver modules
DescriptionModelSpeed and Medium
SFP transceiver 1000BASE-SXAGM731F1G Ethernet short-reach fiber
SFP transceiver 1000BASE-LXAGM732F1G Ethernet long-reach fiber
SFP transceiver 1000BASE-TAGM7341G Ethernet copper
For more information about NETGEAR SFP transceiver modules, visit
netgear.com/business/products/switches/modules-accessories.
Note: If you use a third-party passive direct-attach cable (DAC), the length of the cable
must not exceed 5 meters (16.4 feet).
Hardware Installation Guide15Hardware Overview
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch