Optimize Performance With Quality of Service
32
ProSAFE 8-Port and 16-Port Gigabit Web Managed Click Switch
Enable 802.1p-Based Quality of Service
802.1p-based priority uses a header in the data packet that identifies the class of data in the
packet (for example, voice or video). When 802.1p-based priority is used, the switch reads
information in the packet header to determine the priority to assign to the packet. All ports on
the switch check the packet header and transmit the packet with a priority determined by the
packet content.
Use Browser-Based Access to Enable 802.1p-Based QoS
This feature is enabled by default.
To enable 802.1p-based QoS:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 14.
The login window opens.
4. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Information page displays.
5. Select QoS.
The Quality of Service page displays.
6. In the QoS Mode menu, select 802.1p/DSCP Based.
A message displays warning you that previous QoS settings for the switch will be lost.
7. Click the OK button.
8. Click the Apply button.
Your settings are saved.
Use the ProSAFE Plus Utility to Enable 802.1p-Based QoS
To enable 802.1p-based QoS:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection.
To Next Page
Loading...
Need help?
General
