Name: NETGEAR N600 WNDR3400v3
Brand: NETGEAR
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Troubleshooting

103

N600 Wireless Dual Band Router WNDR3400v3

If all LEDs are still lit 1 minute after power-up:

• Cycle the power to see if the router recovers.

• Press and hold the Restore Factory Settings button to return the router to its factory

settings. See

Factory Settings on page 110.

If the error persists, you might have a hardware problem and should contact technical

support at

www.netgear.com/support.

Internet or Ethernet Port LEDs Are Off

If either the Ethernet port LEDs or the Internet LED does not light when the Ethernet

connection is made, check the following:

• Make sure that the Ethernet cable connections are secure at the router and at the modem

or computer.

• Make sure that power is turned on to the connected modem or computer.

• Be sure that you are using the correct cable:

When connecting the router’s Internet port to a cable or DSL modem, use the cable that

was supplied with the cable or DSL modem. This cable could be a standard

straight-through Ethernet cable or an Ethernet crossover cable.

Wireless LEDs Are Off

If the Wireless LEDs stay off, check to see if the Wireless On/Off button on the router has

been pressed. This button turns the wireless radios in the router on and off. The Wireless

LEDs are lit when the wireless radio is turned on.

The Push 'N' Connect (WPS) Button Blinks Green

If after you use the WPS function the button blinks green, check the following:

• Make sure that you are using the button and not the router’s built-in registrar.

• Check that PIN verification has succeeded for the wireless device you are adding to the

wireless network.

• Make sure that you have not pressed the WPS button on the side of the router after

disabling the WPS feature (you logged in to the router and disabled this previously).

• Check that the router is not in the temporary AP setup locked state (if you are using the

wireless repeater function).

Cannot Log In to the Router

If you are unable to log in to the router from a computer on your local network, check the

following:

Questions and Answers:

Need help?

Do you have a question about the NETGEAR N600 WNDR3400v3 and is the answer not in the manual?

NETGEAR N600 WNDR3400v3 Specifications

General