NETGEAR Nighthawk M5

4. Select Settings > Advanced Settings > Cellular.
The Add APN screen displays.
5. Click the Add button.
The APN page displays.
6.
Specify the APN name.
The APN name is a label for display in the UI.
7.
Specify the APN
This step specifies the APN as defined by the carrier
8.
Change the PDP (data protocol), if necessary:
•
IPV4
•
IPV6
•
IPV4V6
9.
Change the PDP roaming protocol, if necessary:
•
None
•
IPV4
•
IPV6
•
IPV4V6
Note: PDP roaming protocol is the IP protocol used while you are roaming (for
example when you are traveling and the roaming network does not support IPv6).
10. Select the network authentication mode:
•
None
•
PAP
•
CHAP
•
PAP or CHAP
11.
Enter the name and password, if they are required for the network.
12. Click the ADD button.
The entry is added to the table.
User Manual49Maintain Your Mobile Router
Nighthawk M5 5G WiFi 6 Mobile Router