To Next Page

To Previous Page

Use VPN to Access Your Network

144

Nighthawk AC1900 Smart WiFi Router Model R7000

2. Type http://www.routerlogin.net or http://www.routerlogin.com.

A login screen displays.

3. Enter the router user name and password.

The user name is admin. The default password is password. The user name and

password are case-sensitive.

The BASIC Home screen displays.

4. Select ADVANCED > Advanced Setup > VPN Service.

5. On the VPN screen, select the Enable VPN Service radio button.

6. Scroll down to the Clients will use this VPN connection to access section, and select the All

sites on the Internet & Home Network radio button.

When you access the Internet with the VPN connection, instead of using a local Internet

service, you use the Internet service from your home network.

7. Click the Apply button.

Your settings are saved.

8. Click For Windows or For Non Windows button and download the configuration files for

your VPN clients.

9. Unzip the configuration files and copy them to the folder where the VPN client is installed on

your device.

For a client device with Windows 64-bit system, the VPN client is installed at

C:\Program files\OpenVPN\config\ by default.

Block VPN Client Internet Access in the Router

By default, the router is set up this way. It allows VPN connections only to your home

network, not to the Internet service for your home network. If you changed this setting to

allow Internet access, you can change it back.

 To allow VPN clients to access only your home network:

1. Launch an Internet browser from a computer or wireless device that is connected to the

network.