•
Disable: This mode is selected by default. This mode disables LAN port
aggregation on your router. LAN ports 1 and 2 can be used as independent
Ethernet LAN ports.
•
Enable (LACP-IEEE 803.3ad): After you connect the Ethernet cables, the router
communicates with the LAN device that is connected to LAN ports 1 and 2 on
your router, and checks to see if LAN port aggregation is supported on the LAN
device. If LAN port aggregation is supported, the router automatically trunks LAN
ports 1 and 2. If not, LAN ports 1 and 2 work as independent LAN ports. We
recommend that you select this mode unless your LAN device can support a
static link aggregation group (LAG) only.
•
Static: If your device supports a static LAG only, select this mode. Otherwise, we
recommend that you select the Enable (LACP-IEEE 802.3ad) radio button
instead.
NOTE: You must also enable link aggregation on your router before you
connect your device to LAN ports 1 and 2 on the router, otherwise you
will create a network loop.
6. If you made changes, click the Apply button.
Your settings are saved.
User Manual102Manage the WAN and LAN
Network Settings
Nighthawk WiFi 7 Tri-Band Router Model RS600
To Next Page
Loading...
