5. In the Fragmentation Length (256-2346) field for a radio, enter a value from 256
to 2436.
The default value is 2346.
6. In the CTS/RTS threshold (1-2347) field for a radio, enter a value from 1 to 2437.
The default value is 2347.
7. From the Preamble Mode menu for a radio, select the preamble mode:
•
Long Preamble: A long transmit preamble might provide a more reliable
connection or a slightly longer range.
•
Short Preamble: A short transmit preamble might give better performance.
CAUTION: Incorrect settings might disable the radio’s WiFi broadcast
unexpectedly.
8. Click the Apply button.
Your settings are saved.
Use the WPS Wizard for WiFi
connections
WPS (Wi-Fi Protected Setup) lets you connect a WPS-enabled device to your WiFi
network without typing the WiFi password. Instead, you push a software button in the
router web interface or enter a PIN to connect.
If you use the push button method, the device that you are trying to connect must
provide either a physical button or a software button. If you use the PIN method, you
must know the PIN of the device that you are trying to connect.
NOTE: You cannot use the WPS Wizard to connect a device to a guest network.
Use the WPS Wizard with the push button
To use the push button method to connect a WiFi device to your WiFi network, the
device must have either a physical button or a software button.
To use the WPS Wizard with the push button:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
User Manual79Manage WiFi Settings
Nighthawk WiFi 7 Tri-Band Router Model RS600
To Next Page
Loading...
