7. Specify the following settings:
•
Service Name: Enter the name of the custom service or application.
•
Service User: From the Service User menu, select Any, or select Single address
and enter the IP address of one computer:
○
Any: This is the default setting and allows any computer on the Internet to
use this service or application.
○
Single address: Restricts the service or application to a particular computer.
Enter the IP address in the fields, which become available with this selection
from the menu.
•
Service Type: Select the protocol (TCP or UDP) that is associated with the service
or application.
•
Triggering Port: Enter the number of the outbound traffic port that will trigger
opening of the inbound ports when traffic is sensed.
•
Connection Type: Select the protocol (TCP or UDP) that is associated with the
inbound connection. If you are unsure, select TCP/UDP.
•
Starting Port: Enter the start port number for the inbound connection.
•
Ending Port: Enter the end port number for the inbound connection.
8. Click the Apply button.
Your settings are saved and the service or application is added to the Port Triggering
Portmap Table on the Port Forwarding / Port Triggering page.
By default, the rule for the new service or application is enabled.
Change a port triggering rule
You can change an existing port triggering rule.
To change a port triggering rule:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Port Forwarding / Port Triggering.
User Manual174Manage Port Forwarding and
Port Triggering
Nighthawk WiFi 7 Tri-Band Router Model RS600
To Next Page
Loading...
