If the path is functioning correctly, messages display that are similar to those shown
in Test the LAN path to your router on page 188.
3. If you do not receive replies, check the following:
•
Check to see that the IP address of your router is listed as the default gateway
for your computer. If DHCP assigns the IP configuration of your computers, this
information is not visible in your computer Network Control Panel. Verify that the
IP address of the router is listed as the default gateway.
•
Check to see that the network address of your computer (the portion of the IP
address specified by the subnet mask) is different from the network address of
the remote device.
•
Check to see that your cable or DSL modem is connected and functioning.
•
If your ISP assigned a host name to your computer, enter that host name as the
account name on the Internet Setup page.
•
Your ISP might be rejecting the Ethernet MAC addresses of all but one of your
computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address
of your broadband modem. Some ISPs additionally restrict access to the MAC
address of a single computer connected to that modem. If your ISP does this,
configure your router to use the authorized computer’s MAC address (see
Manually set up the Internet connection on page 29).
User Manual190Troubleshooting
Nighthawk WiFi 7 Tri-Band Router Model RS600
To Previous Page
Loading...
