NETGEAR ProSafe GS510TP

Introduction
8
NETGEAR GS510TP Smart Switch
full-duplex mode. The maximum segment length is 328 feet (100 meters) over Category 5
Unshielded Twisted-Pair (UTP) cable.
Features
The following list identifies the key features of the GS510TP Smart Switch:
• Eight RJ-45 10/100/1000 Mbps autosensing Gigabit Ethernet switching ports.
• Two 1000M SFP Gigabit Ethernet switching ports.
• Full NETGEAR Smart Switch functionality.
• Full compatibility with IEEE standards:
• IEEE 802.3 CSMA/CD
• IEEE 802.3i (10BASE-T)
• IEEE 802.3u (100BASE-TX)
• IEEE 802.3x (Full-duplex flow control)
• IEEE 802.3ab (1000BASE-T)
• IEEE 802.3at (PoE+)
• IEEE 802.3z (1000BASE-x)
• IEEE 802.3af (DTE power via MDI)
• IEEE 802.3az (EEE)
• Autosensing and auto-negotiating capabilities for all ports.
• Auto Uplink™ on all ports to make the right connection.
• Automatic address learning function to build the packet-forwarding information table. The
table contains up to 4K Media Access Control (MAC) addresses.
• Store-and-Forward transmission to remove bad packets from the network.
• Full-duplex IEEE 802.3x pause frame flow control.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per port LEDs, power LED, FAN LED, and Max PoE LED.
• Standard NTGR 5 series chassis high.
• NETGEAR Green product features.
• Internal 150W open frame power supply.
• Total power budge is 130W
PoE Features
The GS510TP supports IEEE 802.3at PSE features:
• Ports 1 through 8 support IEEE 802.3at, Alternative A (MDI-X).