NETGEAR ProSafe GS728TP - GS752 TP Front and Back Panel Configuration

10
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch
GS752TP Front Panel and Back Panel Configuration
The GS752TP Gigabit Smart Switch has 48 10/100/1000 Mbps copper ports and four
dedicated 100/1000 Mbps SFP fiber ports.
Each port is capable of sensing the line speed and negotiating the duplex mode with the link
partner automatically.
Figure 2 illustrates the front panel of the GS752TP Gigabit Smart Switch.
Power, Fan, PoE Max,
Link/ACT LEDs
SFP ports
Reset button
and LED Mode LEDs
Factory
Defaults button
Figure 2. Front panel
The front panel contains the following:
• 48 RJ-45 connectors for 10/100/1000 Mbps
AutoSensing Gigabit Ethernet switching
ports.
• Ports 1–8 are PoE+ (30W) capable; ports 9–48 are PoE (15.4W) capable.
• Four dedicated 100M/1000 Mbps SFP Gigabit Ethernet switching ports.
• Reset button to restart the device.
• Recessed Factory Defaults button to restore the device back to the factory defaults.
• Select button to change the working mode of the port LEDs with either PoE mode or
Ethernet mode.
• Port Status and Port Speed LEDs.
• Power
, Fan Status, Max PoE, and LED Mode LEDs.